NEW: High quality turbine housing / manifold available for repairing the unobtainable standard turbo! +39 071715693 / firstname.lastname@example.org
SR190 for Renault 5 GT turbo: high reliability and power at an unbeatable cost!
3 years after about the release of SR175, under the pressure of some tuners interested in obtaining higher powers – well above 200 hp without neglecting the reliability, the SR190 turbo kit was relased. An exceptional turbo both in terms of air flow rates and rotor moment of inertia and general robustness.
SR190 Turbine Carter is made in Niresist D5 (all the cast irons look the same but their resistance is very different and the Niresist D5 is produced only in two foundries in Italy that also take care of the mechanical processing that is very difficult because of the hardness of the material) with a 360° closed thrust bearing, an actuator with a fluoro-silicon membrane resistant to high temperatures and hot stabilized spring, a water-cooled central body … briefly, the best the market can offer today!
The kit is suitable for those who wish to use the car on the track while keeping gear changes above 2,800 – 3,000 rpm. SR190 is very simple to install but obviously allowing higher performance it is advisable to mount it on a well-prepared engine and therefore robust and able to take full advantage of its qualities. For the good preparation of an engine with the objective of mounting the SR190 it is suggested not to modify the cams timing while it is necessary to mount molded pistons, ring head gaskets, steel pipes and obviously the upgrade of the injection. The tuning of the engine should be carried out by a specialized company in order to obtain the best results.
The kit includes:
n. 1 Turbo with 1.2 Bar pre-calibrated actuator (it can be increased up to 1.8 Bar)
n. 1 Collector of gas outlet from the turbo necessary for the correct connection to the exhaust pipe;
n. 1 Oil delivery pipe
n. 1 gasket kit
n. 1 Sticker set